Home Editing Snap

Snap

The snap features allow you to quickly and accurately place pads and traces on a grid or at a specific angle.

To configure Pad2Pad to snap pads and trace ends to the grid enable the Snap-to-grid button on the left toolbar.

To configure Pad2Pad to constrain traces to 45 degree and 90 degree angles enable the Snap-to-angle button on the left toolbar.

To configure Pad2Pad to snap pads, circles, arcs, trace ends to other objects at their key points enable the Snap-to-line button on the left toolbar. Please note that objects of any layer except the attribute layer can only snap to objects of the same layer, objects of the attribute layer can snap to objects of any layer and vice versa.



 

Testimonials

I have been trying out different pcb software all day. I finally found yours and I just had to take the time to tell you, Thank You! I am in the early stages of developing some home automation devices and when I was ready to make a test pcb, I was discouraged big time. Also, please thank the programmers for writing such great code.

Frank S

Polls

Pad2Pad should improve

Layout editor - 29.2%
Footprint library - 33.3%
Auto-router - 12.5%
Four-layer capability - 4.2%
Netlist import - 0%
Add circuit editor - 16.7%
Design Rule Check - 4.2%

Total votes: 24
The voting for this poll has ended on: 10 Dec 2012 - 09:57

Newsletter